After the first generation of products, the best of the five products were chosen by us, we focused on a machine, and we built our cooperation with just one company. Then another series of designs builds, and test cycles were started again. Before the final design was put into production, our design was improved, and it was improved by four machines.
It is basic parameters.
Use our fpc1 (plastic, aluminum, iron, steel and stainless steel) may reduce the dynamic stiffness of this material are considered, so we came to the conclusion, what is the best speed range fpc2? Its best speed range is around 300 to 4500 RPM. As you all know, because we design is a short run, prototype production, and education, 1.5 HP enough spindle power is determined by our, but, 65 IPM is to belong to the speed of the machine movement. It is essential to note that coolant, the standard feature of the coolant control machine, is the decision we make.
Once, providing variable speed as an optional upgrade was also considered. However, if this is a cost-effective upgrade, its foundation should be a simple addition, not a reconfiguration, and it needs to be carefully choreographed. If only a variable speed fpc6 was added, this would be a good solution. In reality, what will be included in the machine that is designed for manual speed change? Includes a single-phase motor and a multi-speed transmission. If you want to upgrade to a variable speed, a three-phase motor will replace the single-phase motor here, with the goal of increasing fpc5 drivers. After the transformation, a complex multi-speed transmission is left behind by the machine, which is completely unnecessary. It should be part of the basic machine design that we decide, instead of providing variable speed, and then using variable speed as an upgrade.